Common Garage Door Problems

 Step 2: Raise and lower the door, staring at the top point of its travel. Mark this area, due to the fact you have to mount the opener in order that the rail is better than the peak of the door's tour. Otherwise, because the door opens, it may strike the rail Garage door repair.

Step three: Inspect the location proper above the garage door at your vertical dividing line; there should be a guide in that area suitable for attaching the the front cease of the rail. If your storage lacks a structural member in that vicinity, set up a front mounting board. Center and fasten a length of 2 X 6-inch plank securely with lag screws throughout two wall studs over your mark of highest door tour. Transfer your high-factor mark to this plank, and expand the vertical door center line onto the plank as properly.

Step four: Attach the rail to the motor unit on the storage ground, following the procedure mentioned in the kit commands. With the garage door down, raise and connect the outermost cease of the rail to the the front mounting plank at a vicinity approximately two inches above the intersecting marks you made on your door's high point and center line. The rail bracket provided for this cause normally fastens to the the front mounting plank with lag screws. If bolts and nuts are furnished, however, you should drill suitable holes through the front mounting plank. Be positive to apply washers beneath the heads of the bolts to preserve them from urgent into the wooden.

Step 5: Raise the motor meeting to the point in which the rail is horizontal, or parallel with the door track. With the motor assembly held or supported in this function, increase and decrease the garage door with the aid of hand to ensure that the rail vicinity does now not intrude with the door's movement. Once you set up an appropriate position and peak for the motor assembly, fasten it to the garage joists with the metallic brackets within the package. If the position of the motor meeting is between  joists, or if the storage joists run the equal route as the rail, you'll want to lock a duration of two X four across the joists, after which mount the brackets to the 2 X four. If your garage ceiling is finished, you could mount a three/four-inch plywood panel overhead, fastening it to the joists with lag screws. Attach the mounting hardware to the plywood panel with heavy-duty toggle bolts.